DJIVE / LED Control

DJive Programs

DJIVE LED Control

DJIVE LED Control is a Windows program for the lights on a DJ booth. You build a playlist of messages, countdowns, and colour looks, watch them on a picture of the booth, and the real panels follow when you turn Live on.

The booth has four panels: one on the left, two across the front, and one on the right. Each panel is a grid of squares. Every lamp in a square shows the same colour, so you choose the colour of a square, not each tiny bulb.

This program is the booth lights. DJIVE Video Wall is a different program: that one is the TV, the guest phones, and the shoutouts. LED Control runs on its own. VirtualDJ is not required, and the video wall does not have to be installed.

What you would use it for

How you run a show

The brightness slider is the picture on the screen. In Settings, each panel has its own level and contrast. Those only change that wall on the real booth, so a panel that looks too bright in the room can be brought down until it matches the others.

Strobe flashes the booth over whatever is playing. It can stay on until you turn it off, or flash only while the button is held.

What you can put on the lights

The booth this is built for

The program matches one booth. Four panels on an H807SA controller, version 63, at 192.168.6.18. A different controller, or panels of a different size, will not line the picture up with the squares.

1 Left72 squares
2 Front left72 squares
3 Front right72 squares
4 Right72 squares
Panels
Four. Left, front left, front right, and right. 288 squares in total.
Each panel
6 columns by 12 rows, 72 squares. Every lamp in a square shows the same colour. The controller counts that square as one pixel.
Colour
Red, green, and blue. 72 squares use the first 216 channels of that panel.
Universes
One universe for each panel. With Start universe set to 1, the controller calls them universe 1, 2, 3, and 4. The program sends those as Art-Net universes 0, 1, 2, and 3, because the controller menu starts at 1.
Universes per port
Leave this at 1. If it is set to 4, the later panels show the wrong colour.

Identify paints the panels so you can see which cable is which: left red, front left green, front right blue, right amber. Panel numbers draws 1, 2, 3, and 4 on those same panels.

Columns 2, 4, and 6 are already flipped, so each column lights from the bottom upward. If a panel is wired the other way, Serpentine columns and reverse pixel order are in Setup.

Controller menu

Version 63. Put these values in the H807SA menu. The controller’s Art-Net address is 192.168.6.18.

Art-Net address
192.168.6.18
DMX address
1
Pixel channel
3
DMX IC type
H801DMX
Light channel
3
IP
18
Net2 input
Net2 to Net1
Port put mode
245
Start univ
1
Universes per port
1
Slave
1

The laptop

Change only the network socket the booth cable is plugged into. Leave Wi-Fi as it is.

IP address
192.168.6.5
Subnet mask
255.255.255.0
Gateway
Leave blank

If Windows is running on a Mac, Settings often will not save this address while the gateway is empty. On that computer use the same IP, subnet prefix 24, gateway 192.168.6.1, and DNS 8.8.8.8. Nothing has to be at that gateway. The controller stays 192.168.6.18, and the socket should say Connected. Control Panel, then the adapter, then IPv4, can still keep the gateway blank.